Another goofy
Towel Holder
© Frank Ford 2006; Photos by FF

It's just a piece of 1/2" steel rod I heated with my propane torch and bent to shape:

Right below where my thumb is in the photo above, I cross drilled and stuck a 1/8" cotter pin through.


The bent rod goes through a washer and into a 1/2" hole in the end of the screwdriver rack on the wall behind my bench:

I now have a swing-away TP holder that never gets in the way but is always handy:


If I drop a piece of PVC pipe on the rod I can use it for paper towels, too:

Back to Machining Index