Final setup:
Look at the neck support jig. If you'd like to know more about this fine setup fixture designed by Dan Erlewine, check in with Stewart MacDonald.
Binding installation:
Fingerboard leveling and fretting:
Notice the neck jig in use here, too.
Setting up a vacuum brace clamping fixture:
"Bag sanding" a 12-fret neck:
Drilling for edge dot inlay:
Clamping a back in place:
I guess that's a big enough press for the job!
Clamping linings:
Fitting the neck joint:
Here's a set of Brazilian rosewood back and sides Richard picked out for a future Gryphon order:
More